Toshiba B-SX8T Manuel D’Utilisation
2. SYSTEM MODE
EO13-33002
2.2 Parameter Setting
2-24
NOTES: 1. If the printer is not used for a few days, the top edge of the media may become curly, which may
cause a paper jam. The Auto Forward Wait Function prevents this problem since the media feed
amount is increased so that the media stops past the platen.
amount is increased so that the media stops past the platen.
2. When the Stop Position Fine Adjustment Value is set in + direction, the media will stop past the
media outlet.
When the value is set in – direction, the media will stop inside the media outlet.
When the value is set in – direction, the media will stop inside the media outlet.
3. This setting will be useful to fine adjust the cut position of labels.
2.2.10 Head Up Cut Selection
This parameter is to choose whether to activate the head up action in the cut issue.
This function prevents ribbon smudges by raising the print head during a reverse feed to the print start
position.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the head up action in cut issue, press the [PAUSE] key.
This function prevents ribbon smudges by raising the print head during a reverse feed to the print start
position.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the head up action in cut issue, press the [PAUSE] key.
NOTES: 1. For the B-SX6T, this function is available only when an optional ribbon saving module (B-SX908-R-
QM-R) is installed
2. The print head may not be raised depending on the rise of the solenoid’s temperature.
2.2.11 Ribbon Save Function Selection
This parameter is to choose whether to activate the Ribbon Saving function or not.
This function enables reducing the ribbon loss caused by taking up unused ribbon during non-print areas.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the ribbon save function, press the [PAUSE] key.
This function enables reducing the ribbon loss caused by taking up unused ribbon during non-print areas.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the ribbon save function, press the [PAUSE] key.
NOTES: 1. For the B-SX6T, this function is available only when an optional ribbon saving module (B-SX908-R-
QM-R) is installed.
2. If this parameter is set to ON without installing a ribbon saving module, the ribbon will be slack
during paper feed or printing, and as a result, printing cannot be performed properly.
Also, be sure to conform the choice to the actual head lever position. Failure to do this may disable
proper ribbon saving function.
Also, be sure to conform the choice to the actual head lever position. Failure to do this may disable
proper ribbon saving function.
<2>PARAMETER SET
HEAD UP CUT OFF
HEAD UP CUT OFF
[RESTART]
[FEED]
HEAD UP CUT OFF
Not activated
HEAD UP CUT ON
Activated
<2>PARAMETER SET
RBN SAVE ON (TAG)
RBN SAVE ON (TAG)
RBN SAVE ON (LBL)
Activated (When the head lever is set to position 1.)
RBN SAVE ON (TAG)
Activated (When the head lever is set to position 2.)
RBN SAVE OFF
Not activated
[RESTART]
[FEED]