Canon iPF8400SE Manuel D’Utilisation

Cause

Corrective Action

The Platen suction is too strong.

In the Control Panel menu, reduce the level of VacuumStrngth.
 (See "Adjusting the Vacuum Strength.")

Close the blue Switch on the platen so that it matches the paper size.
 (See "Setting the Blue Switch on the Platen.")

Incorrect Printhead alignment value.

In the Control Panel menu, set Head Height to a lower height.
 (See "Troubleshooting Paper Abrasion and Blurry Images.")

The type of paper specified in the
printer driver does not match the type
loaded in the printer.

Load paper of the same type as you have specified in the printer driver.
 (See "Loading Rolls in the Printer.")

Make sure the same type of paper is specified in the printer driver as you have loaded in
the printer.

Press the Stop button and stop printing.

Change the type of paper in the printer driver and try printing again.

If printed documents exhibit the following symptoms, adjust the setting of the blue Switch on the Platen.

Image edges are blurred

Image edges are affected by white banding

Important

Always set all of the blue Switches on the Platen to the ● side for borderless printing. If the Switch are not set
correctly, the print quality may deteriorate.

Remove any loaded paper that will not be used.

Sheet  (See "Removing Sheets.")

 

Open the Top Cover.

 

Image edges are blurred or white banding occurs

                                                                                                                                    

iPF8400SE

                                                                                                                                                                                                                     

Troubleshooting

Problems with the printing quality

 

596