Epson L90 Manuel D’Utilisation
Rev. B
Setup 2-37
TM-L90/TM-L90 with Peeler Technical Reference Guide
Note:
The maximum print speed is available for only the one-part energizing mode. However, if the print duty is
too high in the one-part energizing mode, the printer will automatically reduce the printing speed.
too high in the one-part energizing mode, the printer will automatically reduce the printing speed.
The four-part energizing mode reduces power consumption.
The print width can be set in 43 ways with 1 mm pitches in the range from 38 mm to 80 mm. However, it
cannot be set in the range from 71 mm to 79 mm.
cannot be set in the range from 71 mm to 79 mm.
*: Factory setting
Note:
The memory switch serial communication conditions are applied only if the DIP switch 2 setting is "set
with memory switch."
with memory switch."
Selection of the number of parts for
the thermal head energizing
the thermal head energizing
One-part energizing *
Two-part energizing
Three-part energizing
Four-part energizing
Two-part energizing
Three-part energizing
Four-part energizing
Selection of print density
70% 75%
80% 85%
90% 95%
100% * 105%
110% 115%
120% 125%
130% 135%
140%
80% 85%
90% 95%
100% * 105%
110% 115%
120% 125%
130% 135%
140%
Selection of print color
Single color *, two colors
Selection of print speed
Speed level 1 (max. 26 mm/s)
Speed level 2
Speed level 2
Speed level 3
Speed level 4
Speed level 5
Speed level 6 (max. 120 mm/s) *
Speed level 7
Speed level 7
Speed level 8
Speed level 9 (max. 150 mm/s)
Black density for two-color printing
Low, normal *, high
Serial Communication condition
Item
Option
Baud rate
115200 bps
9600 bps
57600 bps
4800 bps
38400 bps
2400 bps
19200 bps
Parity
None/ Odd/ Even
Flow Control
DTR/DSR Control
XON/XOFF Control
XON/XOFF Control
Data Length
7-bit/8-bit
Customized values