Epson 500 Manuel D’Utilisation

EPSON PhotoPC 500

Consumption

Approximately 100 milliwatt at power-on

Approximately 4 W during image

processing

Battery

life

Maximum 12 W during flash discharge

Approximately 300 pictures (high

resolution) can be taken before the

batteries run out. (Using new alkaline

batteries, 150 flashed and 150

non-flashed pictures, without the

EPSON PhotoPix LCD monitor attached).

Replace all four PhotoPC

TM

 500 batteries with any of the

following:

 Single-use AA alkaline batteries*
 Single-use AA lithium batteries (longest battery life)
 Rechargeable AA Ni-Cad batteries
 Rechargeable AA Ni-MI-I batteries

 If you have the PhotoPix LCD monitor, rechargeable or

lithium batteries are recommended.

Note the following when handling batteries:

 Do not use manganese batteries.

Replace all four batteries at the same time.

 Do not drop, puncture, disassemble, or mutilate batteries.

Do not get them wet or expose them to fire.
When the camera is not used for long periods of time,

remove the batteries and store them at a low temperature

in a dry location.

 Dispose of used batteries according to the battery

manufacturer’s instructions and in compliance with all

applicable laws. Contact your local government agency

for information about battery recycling and disposal.
If you use rechargeable Ni-Cad batteries, replace them

with four fully-charged batteries. If your batteries run out

faster after you recharge them a number of times, make

sure you discharge them completely before recharging.

EPSON PhotoPC 500 - 2

10/96

Before you take pictures, check the battery icon on the

control panel. The icon shows how much battery power you

have left, in the following stages:

Full battery power (or AC adapter in use)

Battery power is decreasing

Battery power is low

Battery power is almost out

Change batteries

Follow these steps to install batteries:

Make sure the camera is off, then locate the battery cover

on the bottom of the camera.
Using your fingernail or a small screwdriver, slide the

battery cover lock down in the 

 of the arrow and

hold it in that position while pulling the battery cover

door open.
Insert all four batteries into the compartment, positioning

them as shown.

4. Close the battery cover, making sure that it snaps in place.

Digital Camera