Epson 500 Manuel D’Utilisation

EPSON PhotoPC 500

The control panel keeps track of how many pictures have

been taken. It also gives important information about the

status of the battery and various 

settings.

resolution
mode

\

pictures taken

erase last

/picture

timer

battery level

flash mode

You can adjust the following settings using the control

buttons on the top of the camera:

 Flash
 Resolution

 Timer.

You can also erase the last picture from the camera’s

memory. Flash and resolution settings remain in effect even

after you turn off the camera. However, they return to their

factory settings when you remove or change the batteries.

Flash
The built-in flash has these four settings, which are effective

within a range of 3 to 10 feet:

4

sets the flash to go off automatically

whenever it’s needed (factory setting).

flash to blink rapidly

while the picture is being taken. This prevents

the subject’s eyes from appearing red.

off disables the flash even in inadequate

lighting.

flash sets the flash to go off for every

picture.

The PhotoPC 500 has the following two resolution settings:

resolution images are captured at

640 x 480; the camera can hold up to 30 pictures

at high resolution. This is the factory setting.

S

resolution images are captured at

320 x 240; the camera can hold up to 60 pictures

at this resolution.

The timer sets a lo-second delay between the time the shutter

button is pressed and the image is captured.

Press the erase button with a small pointed object to erase the

last picture from the camera’s memory.

Follow these steps to connect the camera to a PC to transfer

pictures:

1, Press on the arrows on the camera’s port cover and slide up

the cover. (If you have an EPSON PhotoPix LCD monitor

attached to the camera, tilt it up to expose the port cover.)

2. Line up the arrow on the cable connector with the notch on

the camera’s serial port, as shown. Insert the connector.

3. Connect the other end of the cable to one of the computer’s

serial ports and tighten the retaining screws.

4. Turn on the camera and the computer system. A line

appears at the bottom of the picture counter on the

camera’s control panel.

Digital Camera

10/96

EPSON PhotoPC 500 - 3