Epson TM-P60 Manuel D’Utilisation

Rev. D

Setup 2-15

TM-P60 Technical Reference Guide

Note:

For detailed information about the utility and web browser for LAN setting,
see “ Wireless LAN Setup Detailed Information” (page B-1).

2.6.1 Preparing a host PC for setting up a printer

At first, prepare a PC (trial host PC) to set up a printer. The requirements for the trial host PC are
the following:

❏ OS:

Windows 2000 professional, Windows XP professional

❏ Communication port: 802.11b or serial port equipped

When you use the utility (TM Net Win Config Ver. 2.00 or later), you should install it in the host
PC before setting up the TM-P60. See “B.2.1 Install” (page B-4) for the installation procedure.

Note:

When you set up the printer by using wireless LAN, the LAN setting of host PC is changed to correspond
to the LAN setting of TM-P60 temporarily.

There are three way for instaling TM-P60 to wireless LAN. The following table lists required setting item
for trial host PC.

2.6.2 Confirming the current LAN setting of the printer

Confirm the current LAN setting of the printer according following procedure.

1. Turn on the printer’ s power.

2. Open the roll paper cover.

3. Press the FEED button until the printer beeps (about 2 seconds).

4. Close the roll paper cover.

5. The printer prints the current LAN setting (Status sheet).

Using Brawser

Using TM Net Win Config
(in wireless LAN)

Using TM Net Win Config
(with serial interface (RS-232C))

Requi

red items

(wirel

s LA

N i

Networkmode
(commucication mode)

“not required to change any
network items ”

SSID

WEP key

IP address

(On the utility, you have to
select serial I/F communication
condition)

Subnet mask