Epson TM-P60 Manuale Utente
Rev. D
Setup 2-15
TM-P60 Technical Reference Guide
Note:
For detailed information about the utility and web browser for LAN setting,
see “ Wireless LAN Setup Detailed Information” (page B-1).
see “ Wireless LAN Setup Detailed Information” (page B-1).
2.6.1 Preparing a host PC for setting up a printer
At first, prepare a PC (trial host PC) to set up a printer. The requirements for the trial host PC are
the following:
the following:
❏ OS:
Windows 2000 professional, Windows XP professional
❏ Communication port: 802.11b or serial port equipped
When you use the utility (TM Net Win Config Ver. 2.00 or later), you should install it in the host
PC before setting up the TM-P60. See “B.2.1 Install” (page B-4) for the installation procedure.
PC before setting up the TM-P60. See “B.2.1 Install” (page B-4) for the installation procedure.
Note:
When you set up the printer by using wireless LAN, the LAN setting of host PC is changed to correspond
to the LAN setting of TM-P60 temporarily.
to the LAN setting of TM-P60 temporarily.
There are three way for instaling TM-P60 to wireless LAN. The following table lists required setting item
for trial host PC.
for trial host PC.
2.6.2 Confirming the current LAN setting of the printer
Confirm the current LAN setting of the printer according following procedure.
1. Turn on the printer’ s power.
2. Open the roll paper cover.
3. Press the FEED button until the printer beeps (about 2 seconds).
4. Close the roll paper cover.
5. The printer prints the current LAN setting (Status sheet).
Using Brawser
Using TM Net Win Config
(in wireless LAN)
(in wireless LAN)
Using TM Net Win Config
(with serial interface (RS-232C))
(with serial interface (RS-232C))
Requi
red items
(wirel
es
s LA
N i
te
m
s)
Networkmode
(commucication mode)
(commucication mode)
Networkmode
(commucication mode)
(commucication mode)
“not required to change any
network items ”
network items ”
SSID
SSID
WEP key
WEP key
IP address
IP address
(On the utility, you have to
select serial I/F communication
condition)
select serial I/F communication
condition)
Subnet mask
Subnet mask