Sony UP-DR100 Manuel D’Utilisation

Pre

par

ion

Supplied Accessories

Preparation

Supplied Accessories

Make certain you have received the following
accessories:

Notes

• When taking out the printer, be careful not to hurt your

back.

• The packaging materials are needed when

transporting the printer, so we suggest you keep them.

• Before moving the printer, remove the ink ribbon and

paper.

Assembly

Mount the paper scrap tray on the printer.

To remove the Paper scrap tray

Hold both ends of the paper scrap tray and pull it
forward while pushing it down.

To accumulate the ejected printed sheets

Use of the UPA-DR100PS PRINT STACKER (not
supplied) is recommended. Printed sheets for up to one
roll can be accumulated on the stacker regardless of the
type of printing pack used.

Caution

When the UPC-R57/R57A/R68A printing pack is used,
check the location where the printer has been installed.
A space of about 20 cm (7

inches) out from the

printer, and about 20 cm (7

inches) down from the

bottom of the printer is required as shown in the
diagram.

If there is not enough space (as shown in the illustration
above), ejected printed sheets may pile up and clog at the
Paper Output Slot and trouble may occur.

Paper Scrap Tray (1)

Power Cord (1)

CD-ROM (1)
Operating Manual (1)
Software License Agreement (1)
Warranty Card (1)
Service and Customer Support
Information (1)

Paper scrap tray

Match the front edge of
the printer to the edge
of the installation rack.

inches