Sony UP-DR100 Manuel D’Utilisation

Pre

par

at

ion

Connections

8

The UP-DR100 can be connected to computers and 
peripheral devices equipped with a SCSI interface.

• Before making connections, always turn off all 

connected devices.

• Connect the power cord last.
• Refer to the operating manual of each device for 

details of connections between the printer, computer 
and peripherals.

• SCSI cable connectors should be firmly mated at each 

end.

• The total length of SCSI cables connected to a single 

host computer should not be longer than 3 meters.

• When connecting only the printer to a single host 

computer, the SCSI cable should not be longer than 1 
meter.

• To print, a driver is required that corresponds to the 

hardware environment in which the printer is to be 
used.

SCSI cable.
The SCSI connector has been mounted onto the 
slanting surface of the unit for easy insertion of the 
cable. Be sure to insert the SCSI cable straight into the 
SCSI connector as shown in the figure. If you insert 
the SCSI cable into the SCSI connector at angles, this 
may result in bending the small pins inside the SCSI 
connector and it may not work.

The proper SCSI cable to use depends on the computer 
or peripheral device to be connected. Refer to the 
operating manuals for details.
Also, be sure to use a shielded-type cable comforming to 
the FAST SCSI (high impendance) standards.

Turn on any peripheral devices before turning the 
computer on. Make sure that every device in the SCSI 
chain is turned on.

Computer

SCSI Cable 
(not supplied)

To SCSI 
connector

Power Cord (supplied)

To 

-

AC IN 

terminal

To AC power output

DIP Switch 

a)

a) When connecting the printer at the end of the SCSI bus, 

set the internal terminator to ON. (“DIP Switch Settings” 
on page 7)

To disconnect