Epson 286 PLUS Manuel D’Utilisation

If you have forgotten your current password and cannot use your
computer, follow these steps:

1.

2.

3.

4.

5.

6.

Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 5 to disable the
password function by setting jumper J6 to position A.

Caution

Be sure to ground yourself on the back inside panel of

the computer before touching any of the interior

components. Always replace the cover on the computer

before you turn it on again.

Turn on the computer. You do not see the 

Password

:

prompt.

When the 

Press <Del> to start SETUP

prompt appears, press 

Del.

Highlight 

Run SETUP 

and press 

Enter. You 

see the

SETUP menu. Your current password is displayed near the
bottom of the screen.

If you still want to use the same password, be sure to

remember it or write it down. Then go to step 

6.

If you want to change or delete your current password,

follow the instructions under “Setting the Password” 

in

Chapter 2. Be sure to save your SETUP information when

you exit the program.

Turn off the computer and follow the instructions under

“Changing the Jumper Settings” in Chapter 5 to enable the

password function by setting jumper J6 to position B.

D-6 Troubleshooting