Epson 286 PLUS Manuel D’Utilisation

7.

If your computer still does not respond, you can reset it using

the Ctfl 

Alt Del 

command or the 

RESET 

button. See

“Resetting Your Computer” in Chapter 3 for more

information.

8.

If resetting the computer does not work, turn it off and wait

at least five seconds. If you do not have a hard disk drive,

insert the Startup or Reference diskette in drive A. Then

turn on the computer. It should load MS-DOS.

9.

If you installed a display adapter card in your computer, and

you want to use that adapter as your primary display adapter,

you need to change the setting of jumper J3 on the main
system board to disable the built-in VGA adapter. If you
have not set the jumper, you will not see any display on the

screen. You may also need to set jumpers 

J1 

and J5. See

“Changing the Jumper Settings” in Chapter 5 for

instructions.

If you set a password using the SETUP program, you must enter

it before you can use the system. When you turn on the

computer, it runs a memory test. Then the screen displays the

Password

: prompt. If you do not enter the correct

password, you cannot use the computer.

If you have any trouble using your password, try the following:

If you type the password and press 

Enter 

but nothing

happens, type it again and press 

Enter.

If you know the current password but you want to change or

delete it, see Chapter 2 for instructions.

If you do not know the current password, follow the steps

below.

Troubleshooting D-5