Emerson RTM-ATCA-7350 Manuel D’Utilisation
Removing Filler Blades
Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30F)
23
2.5.2
Removing Filler Blades
If the slot is occupied with a filler blade you have to remove it first.
To remove the filler blade, proceed as follows:
1. As shown in step 1 of the figure below, use a screwdriver to anticlockwise loosen
the two captive screws on a filler blade.
2. As shown in step 2 of the figure below, remove the filler blade.
After a filler blade is removed, place it in the equipment room or other moisture-proof
and dust-proof places.
and dust-proof places.
You should install a blank filler blade in the slot after removing the blade. Otherwise, it
may effect the ventilation, heat dissipation, electromagnetic shielding and dust
prevention of the shelf.
may effect the ventilation, heat dissipation, electromagnetic shielding and dust
prevention of the shelf.
If this is the first installation for the shelf, the blade is fully configured and the shelf is
not powered on, you can remove all the filler blades. Then, install blades in the slots in
order. This document takes the first installation as an example.
not powered on, you can remove all the filler blades. Then, install blades in the slots in
order. This document takes the first installation as an example.
If you want to install multiple blades in the shelf that is powered on, you can remove a
filler blade and then install a blade one by one.
filler blade and then install a blade one by one.
Figure 2-2
Removing the Filler Blade
1
1
2