Emerson RTM-ATCA-7350 Manuel D’Utilisation
RTM-ATCA-7350 Installation and Use (6806800H30F)
Hardware Preparation and Installation
Installing and Replacing Daughter Cards
24
2.6
Installing and Replacing Daughter Cards
2.6.1
Precautions
Note the following points at the time of installing or replacing components:
z
Make sure that you wear an electrostatic discharge (ESD)-preventive wrist strap to prevent
the static electricity from hurting you or damaging the device.
the static electricity from hurting you or damaging the device.
z
Keep the area where the components reside clean and keep the components away from
the heat-generating devices, such as radiators.
the heat-generating devices, such as radiators.
Incorrect installation or removal of additional devices or modules may damage the
product or the additional devices or modules.
Before installing or removing additional devices or modules, read the respective
documentation.
product or the additional devices or modules.
Before installing or removing additional devices or modules, read the respective
documentation.
Personal Injury
Power and communication cables
Touching power and communication cables that are energized may cause injuries.
Make sure that the cables cannot be touched while the product is operating.
Power and communication cables
Touching power and communication cables that are energized may cause injuries.
Make sure that the cables cannot be touched while the product is operating.
Electrostatic discharge and incorrect installation and removal of the product can
damage circuits or shorten their life.
Before touching the product or electronic components, make sure that your are
working in an ESD-safe environment.
damage circuits or shorten their life.
Before touching the product or electronic components, make sure that your are
working in an ESD-safe environment.
Do not exert too much force when you insert the blade.
If the blade is not fully aligned with the interface in the backplane, too much force may
twist the pins on the blade or backplane.
If the blade is not fully aligned with the interface in the backplane, too much force may
twist the pins on the blade or backplane.