Emerson RTM-ATCA-7350 Manuel D’Utilisation

To install the FC daughter card, proceed as follows.

1. Wear the ESD-preventive wrist strap. For more information refer, 

.

2. Lay RTM-ATCA-7350 where the FC daughter card is to be installed on the antistatic 

desktop.

3. Insert two plastic supports vertically in the holes used to fasten the FC daughter 

card.

4. At the back side of RTM-ATCA-7350, use a screwdriver to clockwise fasten the two 

screws used to fix the plastic supports.

5. Take the FC daughter card out of the antistatic package.

6. Insert the FC daughter card in RTM-ATCA-7350 by facing the daughter card at an 

angle of 45° to the RTM. Align the daughter card connector with the connector on 
RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports 
on RTM-ATCA-7350. Exert even power downwards until the daughter card 
connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter 
card is fastened by the plastic latches.

7. Insert 

RTM-ATCA-7350

 with the FC daughter card installed in the shelf. For more 

information refer, 

.

After installation, check if RTM-ATCA-7350 can be powered on and work normally. Use the 
optical fiber to connect RTM-ATCA-7350 to the external storage system. Check if RTM-ATCA-
7350 can transmit data normally and monitor whether the FC status indicator is normal.

To replace the FC daughter card, proceed as follows.

1. Wear the ESD-preventive wrist strap. For more information refer, 

.

2. Remove the 

RTM-ATCA-7350

 whose FC daughter card is to be replaced. For more 

information refer, 

3. As shown in step 1 of the figure below, open the plastic latches fastening the FC 

daughter card.

4. Exert even force upwards until the daughter card connector is removed from the 

connector on RTM-ATCA-7350. As shown in step 2 of the figure below, remove the 
daughter card by facing the daughter card at an angle of 45° to the RTM.