Emerson RTM-ATCA-7350 Manuel D’Utilisation

5. Place the removed FC daughter card in an antistatic package.

6. Take the new FC daughter card out of the antistatic package.

7. Insert the FC daughter card in RTM-ATCA-7350 by facing the daughter card at an 

angle of 45° to the RTM. Align the daughter card connector with the connector on 
RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports 
on RTM-ATCA-7350. Exert even power downwards until the daughter card 
connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter 
card is fastened by the plastic latches. See step 3 in the figure above.

8. Install 

RTM-ATCA-7350

 whose FC daughter card is replaced. For more information 

refer, 

.

After replacement, check if RTM-ATCA-7350 can be powered on and work normally. Use the 
optical fibre to connect RTM-ATCA-7350 to the external storage system. Check if RTM-ATCA-
7350 can transmit data normally and monitor whether the FC status indicator is normal.

The following procedure describes the installation of RTM-ATCA-7350. It assumes that your 
system is powered on. If your system is powered off, you can disregard the blue LED and thus 
skip the respective step. In this case it is a purely mechanical installation. The same applies to 
an installation without an installed front blade. In this case disregard the LEDs and skip the 
respective step.

1. Wear the ESD-preventive wrist strap. For more information refer, 

.

2. Unlatch the lower handle of the front blade outward by squeezing the lever and the 

latch together and turning the handle outward only enough to unlatch the handle 
from the face plate, that means until you feel a resistance. Do not rotate the handle 
fully outward.