Emerson RTM-ATCA-7350 Manuel D’Utilisation

10.Insert the main blade. For instructions on how to install the main blade, refer to 

Section 2.7.1.1 Installing the ATCA-7350 in a Powered Shelf in ATCA-7350 
Installation and Use manual.

11.Close the handles of the front blades. The LEDs; OOS LED, Blue LED, and healthy 

LED of RTM are on.

12.Wait until the blue LED on the RTM is OFF.

A switched off blue LED indicates that the payload of the RTM has become active.

To remove RTM-ATCA-7350, proceed as follows:

1. Wear the ESD-preventive wrist strap. For more information refer, 

.

2. Unlatch the lower handle outward by squeezing the lever and the latch together and 

turning the handle outward only enough to unlatch the handle from the face plate, 
that means until you feel a resistance. Do not rotate the handle fully outward.
The blue LED blinks indicating that the shelf manager is informed about the desire 
of the blade to power down the payload of both the front blade and the RTM and the 
power-down process in ongoing. 

3. Wait until the blue LED of the RTM is permanently ON. A permanently switched ON 

LED indicates that the payload of the RTM has been powered down.

4. As shown in step 2 of the figure below, use the screwdriver to unfasten the captive 

screws of the RTM anticlockwise.

5. As shown in step 1 of the figure below, fully open the upper and lower ejector 

handles.