Emerson RTM-ATCA-7350 Manuel D’Utilisation
Zone 3 Connectors
Controls, LEDs and Connectors
RTM-ATCA-7350 Installation and Use (6806800H30F)
43
3.3
Zone 3 Connectors
Zone 3 is composed of three connectors, P30, P31, and P32. The three connectors are used
to connect RTMs with RTM-ATCA-7350s. Zone 3 defines the following signals:
to connect RTMs with RTM-ATCA-7350s. Zone 3 defines the following signals:
z
USB (USB)
z
VGA
z
IPMC SMBus
z
Power (VCC 12VDC, VSBY 5V5)
z
PCI-E Channels
z
General control signals (RTM PRESENT, RTM RST, LEDs)
z
Fabric channel port 0, port 1, port 2, port 3 for the ATCA-7350
3.3.1
P30 Pinout
P30 uses a common 2mm HM connector. P31 uses a half-height ZD connector. P32 uses a ZD
connector.
connector.
Refer to the PICMG specification for the location of the connectors.
The following table shows the P30 pinout. PinA1 on the server blade side is on the top of the
connector while the server blade is placed top side upwards and the face plate is left.
connector while the server blade is placed top side upwards and the face plate is left.
Table 3-3 VGA Port Pin Assignment
Pin
Pin Name
Description
1
RED
Analog red video output signal.
2
GREEN
Analog green video output signal.
3
BLUE
Analog blue video output signal.
4
RESERVED1
Reserved.
5
RESERVED2
Reserved on RTM-ATCA-7350.
6
GROUND1
Connected to the logic ground of RTM-ATCA-7350.
7
GROUND2
Connected to the logic ground of RTM-ATCA-7350.
8
RESERVED3
Reserved on RTM-ATCA-7350.
9
RESERVED4
Reserved, Connected to 5VCC on RTM-ATCA-7350 through
a PTC resistor.
a PTC resistor.
10
GROUND3
Connected to the logic ground of RTM-ATCA-7350.
11
RESERVED5
Reserved.
12
DDC DATA
DDC data pin for CRT.
13
HS
Horizontal sync for Monitor.
14
VS
Vertical sync for Monitor.
15
DDC CLK
DDC pin SCL for CRT.