Emerson ATCA-7150 Manuel D’Utilisation

ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)

information refer, 

After installation, check if RTM-ATCA-7150 can be powered on and work normally. Use the 
optical fiber to connect RTM-ATCA-7150 to the external storage system. Check if RTM-ATCA-
7150 can transmit data normally and monitor whether the FC status indicator is normal.

To replace the FC daughter card, proceed as follows.

1. Wear the ESD-preventive wrist strap. For more information refer, 

2. Remove the RTM-ATCA-7150 whose FC daughter card is to be replaced. For more 

information refer, 

.

3. As shown in step 1 of the figure below, open the plastic latches fastening the FC 

daughter card.

4. Exert even force upwards until the daughter card connector is removed from the 

connector on RTM-ATCA-7150. As shown in step 2 of the figure below, remove the 
daughter card by facing the daughter card at an angle of 45° to the RTM.

5. Place the removed FC daughter card in an antistatic package.