Emerson 40-200KVA Mode D'Emploi

Follow the steps below to connect the input wiring:

1. Locate the input wiring access (top or bottom access), remove the conduit landing plate and punch 

the appropriate size hole for the size conduit being used. Pull the three/four input wires through 

it, allowing some slack for installation. For cabinets that are located to the immediate left of the 

UPS, the access plate is on the lower right of the cabinet. Remove the access plate and verify that 

the edge guarding is installed and intact.

2. Secure the conduit to the access plate of the Liebert BDC.
3. Input power cables connect to the system input circuit breaker; refer to Figure 21 and Table 34.
4. Connect the ground (earth) wire to the earth busbar and tighten it to 240lb-in. (27N-m) (M10 

bolt).

5. Locate UPS input and output cables and access panel to UPS on lower right side.

6. Connect the system ground cable between the Liebert BDC and UPS and tighten the connections 

to 240lb-in. (27N-m) (M10 bolt).

7. Connect the system input cables between the Liebert BDC “UPS Input” Busbars (A-B-C N 

terminals) and UPS input busbars (A-B-C N terminals) and tighten the connections to 240lb-in. 

(27N-m) (M10 bolt).

8. Connect the system output cables between the Liebert BDC 'UPS Output' Busbars (A-B-C N 

terminals) and UPS output busbars (A-B-C N terminals) and tighten the connections to 240lb-in. 

(27N-m) (M10 bolt).

Risk of improper wiring connection. Can cause equipment damage.
The control wire must be installed to ensure proper operation of the system and fully protect 

the load when switching between bypass cabinet and UPS.