Mitsubishi Electronics WL7200U Manuel D’Utilisation

EN-57

You can replace the lens on this projector. The lens 
can be replaced with the separately sold option lens 
according to the usage environment of the projector. 
For details of the specification of the option lens, 
contact your local dealer. 

•  Before you replace the lens, be sure to turn off the

projector and unplug the power cord from the wall 
outlet. 

•  Before you replace the lens, be sure to reset the

lens position to the center (the factory default 

position).

  When the lens position is moved from the center, 

reset to the center position (the factory default 

position) using the lens shift reset (see page 33).

  The lens replacement may fail when the lens 

position is moved from the center.

•  The projector and lens are composed of precision

parts. Do not subject them to shock or excessive 
force.

•  During replacement, do not touch the lens surface

with your hands.

•  Take sufficient care not to attach any dirt or oil

on the lens surface, and not to scratch the lens 
surface.

•  Do not replace the lens in a dusty place. Dirt or

dust entering the projector causes a degradation of 
an image quality.

•  Do not leave the lens removed from the projector

for a long period of time. Dirt or dust entering the 
projector causes a degradation of an image quality.

•  Do not touch the signal contact of the lens with

your finger. When dirt or dust adheres, it may cause 
a contact failure.

1.  Remove the lens ring by turning it counterclockwise 

slightly.

Lens ring

2.  Turn the lens counterclockwise until it stops while 

pressing the lens release button on the top of the 
cabinet as far as it will go, and then remove the 
lens by pulling it out slowly.

• Do not drop the lens when removing it.

         

Lens release button

Lens

1.  Remove the lens protective cap from the lens.

Lens

Protective cap

•  Don’t attach the protective cap to the lens after

mounting the lens to the projector.

2.  Insert the lens slowly as far as it will go with the red 

mark on the lens pointed upward in the center.

                 

Red mark

3.  Turn the lens clockwise slowly until you hear it 

click.

•  Do not press the lens release button when

mounting the lens.

•  After you mount the lens, turn it counterclockwise

and check that it isn’t removed.

4.  Mount the lens ring by turning it clockwise.

                 

Lens ring

Important:
•  Do not transport the projector with the option lens

mounted. The projector may be damaged.

•  With the option lens mounted, the brightness,

resolution, and color uniformity in the projected 
image may differ from those with the standard lens.

•  With the option lens mounted, the adjustable angle

in the keystone adjustment differs from that with 
the standard lens.

•  In the keystone adjustment with the option lens

mounted, the proper aspect ratio may not be 
obtained.

•  When the option lens is mounted, projected images

may become distorted, have decreased resolution, 
or have shadows at their corners if the projection 
screen is set close to the top or bottom edge or 
right or left edge of the effective projection area.