Q-Logic 64 Manuel D’Utilisation
6 – Removal/Replacement
Cross-Connect Blades
59043-03 A
6-11
D
6.4
Cross-Connect Blades
The SANbox2-64 switch contains two CC blades: one in slot 11 (CC blade 0) and
the other in slot 12 (CC blade 1) as shown in
the other in slot 12 (CC blade 1) as shown in
. You access slot 11 by
removing the top-rear switch cover. To access slot 12, you remove the bottom-
rear switch cover. Other than this, the procedure for replacing either CC blade is
the same.
rear switch cover. Other than this, the procedure for replacing either CC blade is
the same.
Figure 6-3. CC Blade Slots
CAUTION!
Always use an ESD wrist strap when removing and installing a CC
blade.
The CC blade contains sensitive logic components. To avoid
damage to the module, do not touch the CPU module components.
Keep the CC blade in an ESD protective container or anti-static
bag when not in use.
blade.
The CC blade contains sensitive logic components. To avoid
damage to the module, do not touch the CPU module components.
Keep the CC blade in an ESD protective container or anti-static
bag when not in use.
Slot 11
Slot 12
Top-Rear
Switch Cover