Nortel Networks CVX 600 Manuel D’Utilisation
296-1011-202 Rel. 5.0, Doc. Rev. 02.01
iii
Regulatory and Safety
Regulatory Information
U.S.A. Requirements
FCC Radio Frequency Notice for the CVX 600 Access Switch
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that may cause undesired
operation.
operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Part 68 General Information
This equipment complies with Part 68 of the FCC rules. This equipment uses the following USOC RJ-48 jacks:
Interface
Service Code
Facility Code
1.544 Mb/s superframe format (SF) without
line power
line power
6.0N
04DU9-BN
1.544 Mb/s superframe format (SF) and
B8ZS without line power
B8ZS without line power
6.0N
04DU9-DN
1.544 Mb/s ANSI extended superframe
format (ESF) without line power
format (ESF) without line power
6.0N
04DU9-1KN
1.544 Mb/s ANSI extended superframe
format (ESF) and B8ZS without line power
format (ESF) and B8ZS without line power
6.0N
04DU9-1SN