Q-Logic SANBOX2-8C Manuel D’Utilisation
B – Command Line Interface
Set Config Command
B-24
59042-00 A
Set Config Command
Sets switch, port, and zoning configuration parameters.
Authority
Admin authority within a Config Edit session
Syntax
set config
port [port_number]
ports [port_number]
switch
zoning
ports [port_number]
switch
zoning
Keywords
port [port_number]
Changes configuration parameters for the port number given by [port_number]. If
you omit this value, the system begins with port 0 and proceeds in order through
port 15 or until you enter “qq”. The system displays each parameter one line at a
time and prompts you for a value. For each parameter, enter a new value or press
the Enter key to accept the current value shown in brackets.
Changes configuration parameters for the port number given by [port_number]. If
you omit this value, the system begins with port 0 and proceeds in order through
port 15 or until you enter “qq”. The system displays each parameter one line at a
time and prompts you for a value. For each parameter, enter a new value or press
the Enter key to accept the current value shown in brackets.
ports [port_number]
Very similar to the Set Config Port command, except that any attribute value that
is changed by the user is applied to ALL ports. ONLY attribute values that are
changed are updated; the attribute values that are not changed are left alone.
Ports are numbered beginning with 0. The default is port 0. The system displays
each parameter one line at a time and prompts you for a value. For each
parameter, enter a new value or press the Enter key to accept the current value
shown in brackets. Admin and config edit modes are required for this command.
Very similar to the Set Config Port command, except that any attribute value that
is changed by the user is applied to ALL ports. ONLY attribute values that are
changed are updated; the attribute values that are not changed are left alone.
Ports are numbered beginning with 0. The default is port 0. The system displays
each parameter one line at a time and prompts you for a value. For each
parameter, enter a new value or press the Enter key to accept the current value
shown in brackets. Admin and config edit modes are required for this command.
Table B-6. Set Config Port Parameters
Parameter
Description
AdminState
Port administrative state: online, offline,
diagnostics, or down.
diagnostics, or down.
LinkSpeed
1Gb/sec or 2 Gb/sec
PortType
Type of port
TLPortMode
Initiates the configuration of ports
attributes. Indicates whether using initiator
or target devices on the loop. If
[port_number] is specified then the user
will be presented with attributes for that
port only; otherwise, all attributes for all
ports will be available for configuration.
attributes. Indicates whether using initiator
or target devices on the loop. If
[port_number] is specified then the user
will be presented with attributes for that
port only; otherwise, all attributes for all
ports will be available for configuration.