Q-Logic SANBOX2-8C Manuel D’Utilisation
B – Command Line Interface
Set Config Command
B-26
59042-00 A
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table B-7. Set Config Switch Parameters
Parameter
Description
AdminState
Switch administrative state: online, offline,
or diagnostics.
or diagnostics.
Broadcast Enable
Enables or disables (default) forwarding if
broadcasting frames.
broadcasting frames.
DefaultDomainID
Default domain ID setting
DomainIDLock
If set to True (default), prevents domain ID
from being changed.
from being changed.
SymbolicName
Descriptive name
R_T_TOV
Receiver Transmitter Timeout Value.
Specifies the number of milliseconds a
port is to wait to receive a response from
another port. The default is 100.
Specifies the number of milliseconds a
port is to wait to receive a response from
another port. The default is 100.
R_A_TOV
Resource Allocation Timeout Value. The
number of milliseconds the switch waits to
allow two ports to allocate enough
resources to establish a link. The default is
10000.
number of milliseconds the switch waits to
allow two ports to allocate enough
resources to establish a link. The default is
10000.
E_D_TOV
Error Detect Timeout Value. The number
of milliseconds a port is to wait for errors to
clear. The default is 2000 msec.
of milliseconds a port is to wait for errors to
clear. The default is 2000 msec.
FS_TOV
Fabric Stability Timeout Value. The default
is 5000 msec.
is 5000 msec.
DS_TOV
Distributed Services Timeout Value
(Management Server, Name Server). The
default is 5000 msec.
(Management Server, Name Server). The
default is 5000 msec.
PrincipalPriority
The priority used in the FC-SW-2 principal
switch selection algorithm. 1 is high, 255 is
low.
switch selection algorithm. 1 is high, 255 is
low.
Description
The name for the configuration. The
default is undefined.
default is undefined.