Q-Logic 59021-05 Manuel D’Utilisation
B – Command Line Interface
Set Setup Command
59021-05 A
B-39
system
Prompts you in a line-by-line fashion to change system configuration settings.
Prompts you in a line-by-line fashion to change system configuration settings.
describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity
Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is “public”.
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is “public”.
AuthFailureTrap
Specifies the IP address where a notification is sent in the
event of an authentication failure.
event of an authentication failure.
Table B-12. System Configuration Settings
Entry
Description
Eth0NetworkAddress
Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask
Subnet mask address for the Ethernet port.
Eth0GatewayAddress
IP address gateway.
Eth0NetworkDiscovery
Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 -
RARP)
RARP)
AdminTimeout
Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session.
Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
waits before terminating an idle Admin session.
Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
SecurityEnabled
Enables or disables the enforcement of account
names and passwords.
names and passwords.
LocalLogEnabled
Enables or disables the saving of log information
on the switch.
on the switch.
RemoteLogEnabled
Whether remote logging of is enabled or disabled.
If enabled, log information is saved to a remote
host that supports the syslog protocol.
If enabled, log information is saved to a remote
host that supports the syslog protocol.
RemoteLogHostIPAddress
The IP address of the host that will receive the
remote log information if remote logging is
enabled.
remote log information if remote logging is
enabled.
Table B-11. SNMP Configuration Settings
Entry
Description