Q-Logic 5600 Manuel D’Utilisation

4 – Managing Switches

Configuring a Switch

4-34

59097-02 B

S

The SNMP trap configuration defines how traps are set. Choose from the tabs 
Trap1 – Trap 5 to configure each trap. 

 describes the SNMP 

configuration parameters.

                                                                                           

Trap Version

Specifies the SNMP version (1 or 2) with which to format traps.

Trap 1 Enabled

Enables or disables the trap. If disabled, traps are not configurable.

Trap Address

1

1

Trap address (other than 0.0.0.0) and trap port combinations must be unique. For example, if trap 1 and trap

2 have the same address, then they must have different port values. Similarly, if trap 1 and 2 have the same
port value, they must have different addresses.

Specifies the IP address to which SNMP traps are sent. A maximum 
of 5 trap addresses are supported. The default address for trap 1 is 
10.0.0.254. The default address for traps 2–5 is 0.0.0.0.

Trap Port

1

The port number on which the trap is sent. The default is 162.

Trap Severity

Specifies a severity level to assign to the trap. Open the pull-down 
menu and choose a level. The Trap 1 Enabled check box on the 
SNMP Properties dialog must be enabled to access this pull-down 
menu. Trap severity levels include Unknown, Emergency, Alert, Criti-
cal, Error, Warning, Notify, Info, Debug, and Mark