Q-Logic 5600 Manuel D’Utilisation

Page de 336
A – Command Line Interface
Set Config Command
59097-02 B
A-65
A
LinkSpeed
Transmission speed:
„ 1/2/4-Gbps Ports: 1-Gbps, 2-Gbps, 4-Gbps, or Auto. The 
default is Auto.
„ 10-Gbps Ports: 10-Gbps
PortType
Port type:
„ 1/2/4-Gbps Ports: GL, G, F, FL, Donor. The default is GL.
„ 10-Gbps Ports: G
SymbolicPortName
Descriptive name for the port. The name can be up to 32 
characters excluding #, semicolon (;), and comma (,). The 
default is Port n where n is the port number.
ALFairness
(1/2/4-Gbps ports only)
Arbitration loop fairness. Enables (True) or disables (False) 
the switch’s priority to arbitrate on the loop. The default is 
False.
DeviceScanEnabled
Enables (True) or disables (False) the scanning of the con-
nected device for FC-4 descriptor information during login. 
The default is True.
ForceOfflineRSCN
Enables (False) or disables (True) the immediate transmis-
sion of RSCN messages when communication between a 
port and a device is interrupted. If enabled, the RSCN mes-
sage is delayed for 200 ms for locally attached devices and 
400 ms for devices connected through other switches. The 
default is False. This parameter is ignored if IOStreamGuard 
is enabled.
ARB_FF
(1/2/4-Gbps ports only)
Send ARB_FF (True) instead of IDLEs (False) on the loop. 
The default is False.
InteropCredit
Interoperability credit. The number of buffer-to-buffer credits 
per port. 0 means the default (16) is unchanged. Changing 
interoperability credits is necessary only for E_Ports that are 
connected to non-FC-SW-2-compliant switches. Contact your 
authorized maintenance provider for assistance in using this 
feature.
ExtCredit
(1/2/4-Gbps ports only)
Extended credits. The number of port buffer credits that this 
port can acquire from donor ports. The default is 0.
FANEnable
(1/2/4-Gbps ports only)
Fabric address notification. Enables (True) or disables 
(False) the communication of the FL_Port address, port 
name, and node name to the logged-in NL_Port. The default 
is True.
Table A-18. Set Config Port Parameters  (Continued)
Parameter
Description