Q-Logic 8C/16 Manuel D’Utilisation

A – Command Line Interface
Reset Command

A-22

59022-06 A

Q

Resets the switch configuration parameters. If you omit the keyword, the default is 
Reset Switch.

Admin

config [config_name]
factory
port [port_number]
snmp
switch (default)
system
zoning

config [config_name]
Resets the configuration given by [config_name] to the factory default values for 
switch, port, alarm threshold, and zoning configuration. If [config_name] does not 
exist on the switch, a configuration with that name will be created. If you omit 
[config_name], the active configuration is reset. You must activate the 
configuration for the changes to take effect. Refer to 

 through 

for switch, port, and alarm threshold configuration default values.
factory
Resets switch configuration, port configuration, alarm threshold configuration, 
zoning configuration, SNMP configuration, system configuration, and zoning to 
the factory default values. The switch configuration is activated automatically. 
Refer to 

 through 

.

port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning 
with 0.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to 

 for SNMP configuration default values.

switch
Resets the switch without a power-on self test. This reset disrupts traffic and 
activates the pending firmware. This command also closes all management 
sessions. This is the default. To reset the switch with a power-on self test, refer to 
the 

. To reset the switch without disrupting 

traffic, refer to the 

.

system
Resets the system configuration settings to the factory default values. Refer to 

 for system configuration default values.

zoning
Clears the zoning database and deactivates the active zone set. The zoning 
configuration values (autosave, default visibility) remain unchanged.