Q-Logic 8C/16 Manuel D’Utilisation

3 – Managing Fabrics
Managing the Fabric Database

3-6

59022-06 A

Q

The archive/restore works for all switches. However, the Restore menu item is not 
available for the inband switches. You can only restore a switch out-of-band (the 
connection switch). Use the following procedure to replace a failed switch for 
which an archive is available. 

1.

At the failed switch:
a.

Turn off the power and disconnect the AC cords.

b.

Note port locations and remove the interconnection cables and SFPs.

c.

Remove the failed switch.

2.

At the replacement switch:
a.

Mount the switch in the location where the failed switch was removed.

b.

Install the SFPs using the same ports as were used on the failed 
switch.

c.

Attach the AC cords and power up the switch.

3.

Select the failed switch in the topology display. Open the Switch menu and 
select Delete.

4.

Restore the configuration from the failed switch to the replacement switch:
a.

Open the faceplate display for the replacement switch. Open the 
Switch menu and select Restore.

b.

In the Restore dialog, enter the archive file from the failed switch or 
browse for the file.

c.

Choose the Restore button.

5.

Reconnect the inter-switch links, target devices, and initiator devices to the 
replacement switch using the same ports as were used on the failed switch.

6.

Reset the replacement switch to activate the configuration formerly 
possessed by the failed switch including the domain ID and the zoning 
database. Open the Switch menu and select Reset Switch.

Do not reconnect inter-switch links, target devices, and 
initiator devices at this time. Doing so could invalidate 
the fabric zoning configuration.