Q-Logic 5200 Manuel D’Utilisation

A – Command Line Interface
Set Setup Command

A-56

59056-02 A

0

Changes SNMP and system configuration settings. The switch maintains one 
SNMP configuration and one system configuration.

Admin session

snmp
system

snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings. 

 describes the SNMP fields. For each parameter, enter a new value or 

press the Enter key to accept the current value shown in brackets.

SNMPEnabled

Enables (True) or disables (False) SNMP on the switch. The 
default is True.

Contact

Specifies the name of the person to be contacted to respond 
to trap events. The name can be up to 64 characters 
excluding #, semicolon (;), and comma (,). The default is 
undefined.

Location

Specifies the name of the switch location. The name can be 
up to 64 characters excluding #, semicolon (;), and comma 
(,). The default is undefined.

Trap [1-5] Address

Specifies the workstation IP address to which SNMP traps 
are sent. The default address for trap 1 is 10.0.0.254. The 
default address for traps 2–5 is 0.0.0.0. Addresses, other 
than 0.0.0.0, for all traps must be unique.

Trap [1-5] Port

Specifies the workstation port to which SNMP traps are sent. 
Valid workstation port numbers are 1–65535. The default is 
162.

Trap [1-5] Severity

Specifies the severity level to use when monitoring trap 
events. The default is Warning

Trap [1-5] Version

Specifies the SNMP version (1 or 2) to use in formatting 
traps. The default is 2.

Trap [1-5] Enabled

Specifies whether traps (event information) are enabled or 
disabled (default).