Q-Logic 5200 Manuel D’Utilisation

A – Command Line Interface
Set Setup Command

A-58

59056-02 A

0

Eth0NetworkMask

Ethernet subnet mask address.

Eth0GatewayAddress

Ethernet IP address gateway.

AdminTimeout

Amount of time in minutes the switch waits before 
terminating an idle Admin session. Zero (0) 
disables the time out threshold. The default is 30, 
the maximum is 1440.

InactivityTimeout

Amount of time in minutes the switch waits before 
terminating an idle Telnet command line interface 
session. Zero (0) disables the time out threshold. 
The default is 0, the maximum is 1440.

LocalLogEnabled

Enables (True) or disables (False) the saving of log 
information on the switch. The default is True.

RemoteLogEnabled

Enables (True) or disables (False) the recording of 
the switch event log on a remote host that supports 
the syslog protocol. The default is False.

RemoteLogHostAddress

The IP address of the host that will receive the 
switch event log information if remote logging is 
enabled. The default is 10.0.0.254.

NTPClientEnabled

Enables (True) or disables (False) the Network 
Time Protocol (NTP) client on the switch. This 
client enables the switch to synchronize its time 
with an NTP server. This feature supports NTP 
version 4 and is compatible with version 3. An 
Ethernet connection to the server is required and 
you must first set an initial time and date on the 
switch. The synchronized time becomes effective 
immediately. The default is False.

NTPServerAddress

The IP address of the NTP server from which the 
NTP client acquires the time and date. The default 
is 10.0.0.254.

EmbeddedGUIEnabled

Enables (True) or disables (False) the SANsurfer 
Switch Manager Web applet. Changing this 
parameter to False while the applet is running will 
terminate the applet. The default is True.