Q-Logic SANBOX2-16 Manuel D’Utilisation
59022-11 A
A-1
Appendix A
Command Line Interface
The command line interface (CLI) enables you to perform a variety of fabric and
switch management tasks through an Ethernet or a serial port connection. This
section describes the following:
switch management tasks through an Ethernet or a serial port connection. This
section describes the following:
A.1
Logging On to a Switch
To log on to a switch using Telnet, open a command line window on the
workstation and enter the Telnet command followed by the switch IP address:
workstation and enter the Telnet command followed by the switch IP address:
# telnet ip_address
A Telnet window opens prompting you for a login. Enter an account name and
password.
password.
To log on to a switch through the serial port, configure the workstation port with the
following settings:
following settings:
9600 baud
8-bit character
1 stop bit
No parity
Enter an account name and password when prompted.