Netgear M4100-50G Manuel D’Utilisation

IPv6 Address/Length is ........................ 3099::210:18FF:FE82:337/64

IPv6 Default Router is ........................ FE80::204:76FF:FE73:423A

Burned In MAC Address.......................... 00:10:18:82:03:37

Locally Administered MAC Address............... 00:00:00:00:00:00

MAC Address Type............................... Burned In

Network Configuration Protocol Current......... None

Management VLAN ID............................. 1

Web Mode....................................... Enable

Java Mode...................................... Enable

Console Port Access Commands

This section describes the commands you use to configure the console port. You can use a 
serial cable to connect a management host directly to the console port of the switch.

Use this command to access Global Config mode. From Global Config mode, you can 
configure various system settings, including user accounts. You can also enter other 
command modes, including Line Config mode.

configuration

Use this command to access Line Config mode, which allows you to configure various Telnet 
settings, ssh settings, and the console port. 

line {console | telnet | ssh}

Use this command to specify the communication rate of the terminal interface. The supported 
rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.

serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 

Privileged EXEC

Global Config

115200

Line Config