Netgear M4100-50G Manuel D’Utilisation

Use this command in line configuration mode to specify an authentication method list when 
the user accesses a higher privilege level in remote telnet or console.

enable authentication {default | list-name}

Use this command to return to the default specified by the 

enable authentication

 

command. 

no enable authentication {default | list-name}

Use this command to display serial communication settings for the switch.

show serial

• Privileged EXEC

• User EXEC

Telnet Commands

This section describes the commands you use to configure and view Telnet settings. You can 
use Telnet to manage the device from a remote management host.

Line Config

Line Config

The time, in minutes, of inactivity on a Serial port connection, after which the Switch will 
close the connection. Any numeric value from 0 through 160 is allowed, the factory 
default is 5. A value of 0 disables the timeout. 

The default baud rate at which the serial port will try to connect. The available values are 
1200, 2400, 4800, 9600, 19200, 38400,57600, and 115,200 baud. The factory default is 
9600 baud.

The number of bits in a character. The number of bits is always 8. 

Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is 
always disabled.

The number of Stop bits per character. The number of Stop bits is always 1.

The parity method used on the serial port. The parity method is always None.