3com WX3000 Manuel D’Utilisation

 

1-5 

Follow these steps to enable GVRP on an Ethernet port: 

Enter system view 

system-view 

— 

Enable GVRP globally 

Required 

By default, GVRP is disabled globally. 

Enter Ethernet port view 

interface interface-type 
interface-number 

— 

Enable GVRP on the port 

Required 

By default, GVRP is disabled on the port.

 

After you enable GVRP on a trunk port, you cannot change the port to a different type. 

 

Follow these steps to configure GVRP timers: 

Enter system view 

system-view 

— 

Configure the LeaveAll timer 

garp timer leaveall 
timer-value 

Optional 

By default, the LeaveAll timer is set 
to 1,000 centiseconds. 

Enter Ethernet port view 

interface interface-type 
interface-number 

— 

Configure the Hold, Join, and 
Leave timers 

garp timer { hold | join | 
leave } timer-value 

Optional 

By default, the Hold, Join, and Leave 
timers are set to 10, 20, and 60 
centiseconds respectively. 

 

Note that: 

z 

The setting of each timer must be a multiple of 5 (in centiseconds).  

z 

The timeout ranges of the timers vary depending on the timeout values you set for other timers. If 

you want to set the timeout time of a timer to a value out of the current range, you can set the 

timeout time of the associated timer to another value to change the timeout range of this timer. 

The following table describes the relations between the timers: