3com WX3000 Manuel D’Utilisation

1-7

GVRP Configuration Example

Network requirements

Enable GVRP on all the switches in the network so that the VLAN configurations on Switch C and

Switch E can be applied to all switches in the network, thus implementing dynamic VLAN

information registration and refresh, as shown in

By configuring the GVRP registration modes of specific Ethernet ports, you can enable the

corresponding VLANs in the switched network to communicate with each other.

Figure 1-2 Network diagram for GVRP configuration

Switch C

Switch E

GEth1/0/1

Switch A

Switch B

Switch D

VLAN 5

VLAN 8

VLAN 5
VLAN 7

GEth1/0/1

GEth1/0/2

GEth1/0/3

GEth1/0/2

GEth1/0/1

Configuration procedure

1) Configure Switch A

# Enable GVRP globally.

<SwitchA> system-view

[SwitchA] gvrp

# Configure GigabitEthernet 1/0/1 to be a trunk port and to permit the packets of all the VLANs.

[SwitchA] interface GigabitEthernet 1/0/1

[SwitchA-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-GigabitEthernet1/0/1] port trunk permit vlan all

# Enable GVRP on GigabitEthernet 1/0/1.

[SwitchA-GigabitEthernet1/0/1] gvrp

[SwitchA-GigabitEthernet1/0/1] quit

# Configure GigabitEthernet 1/0/2 to be a trunk port and to permit the packets of all the VLANs.

[SwitchA] interface GigabitEthernet 1/0/2

[SwitchA-GigabitEthernet1/0/2] port link-type trunk

[SwitchA-GigabitEthernet1/0/2] port trunk permit vlan all

# Enable GVRP on GigabitEthernet 1/0/2.

[SwitchA-GigabitEthernet1/0/2] gvrp

[SwitchA-GigabitEthernet1/0/2] quit

# Configure GigabitEthernet 1/0/3 to be a trunk port and to permit the packets of all the VLANs.

[SwitchA] interface GigabitEthernet 1/0/3

[SwitchA-GigabitEthernet1/0/3] port link-type trunk