3com WX3000 Manuel D’Utilisation

 

1-8 

<device> system-view 

[device] interface GigabitEthernet 1/0/1 

[device-GigabitEthernet1/0/1] shutdown 

[device-GigabitEthernet1/0/1] 

%Apr  2 08:11:14:220 2000 device L2INF/5/PORT LINK STATUS CHANGE:- 1 -  

 GigabitEthernet1/0/1 is DOWN 

[device-GigabitEthernet1/0/1] undo shutdown 

[device-GigabitEthernet1/0/1] 

%Apr  2 08:11:32:253 2000 device L2INF/5/PORT LINK STATUS CHANGE:- 1 -  

 GigabitEthernet1/0/1 is UP 

# Disable GigabitEthernet 1/0/1 from outputting Up/Down log information, execute the shutdown 

command or the undo shutdown command on GigabitEthernet 1/0/1, and no Up/Down log information 

is output for GigabitEthernet 1/0/1.  

[device-GigabitEthernet1/0/1] undo enable log updown 

[device-GigabitEthernet1/0/1] shutdown 

[device-GigabitEthernet1/0/1] undo shutdown 

To make some other ports have the same configuration as that of a specific port, you can copy the 

configuration of the specific port to the ports.  

Specifically, the following types of port configuration can be copied from one port to other ports: VLAN 

configuration, protocol-based VLAN configuration, LACP configuration, QoS configuration, GARP 

configuration, STP configuration and initial port configuration. For the detailed copy content, please 

refer to the Command Manual. 

Follow these steps to copy port configuration to other ports: 

Enter system view  

— 

Copy port configuration 
to other ports  

copy configuration source { interface-type 
interface-number | aggregation-group 
source-agg-id } destination { interface-list 
[ aggregation-group destination-agg-id ] | 
aggregation-group destination-agg-id } 

Required 

 

z 

If you specify the source aggregation group ID, the system uses the port with the smallest port 

number in the aggregation group as the source.  

z 

If you specify the destination aggregation ID, the configuration of the source port will be copied to 

all ports in the aggregation group.  

 

To make the configuration task easier for users, certain devices allow users to configure on a single port 

as well as on multiple ports in a port group. In port group view, the user only needs to input the