3com WX3000 Manuel D’Utilisation

 

1-6 

A load-sharing aggregation group contains at least two selected ports, but a non-load-sharing 

aggregation group can only have one selected port at most, while others are unselected ports. 

 

 

z 

The commands of link aggregation cannot be configured with the commands of port loopback 

detection feature at the same time. 

z 

The ports where the mac-address max-mac-count command is configured cannot be added to 

an aggregation group. Contrarily, the mac-address max-mac-count command cannot be 

configured on a port that has already been added to an aggregation group. 

z 

MAC-authentication-enabled ports and 802.1x-enabled ports cannot be added to an aggregation 

group.  

z 

Mirroring destination ports and mirroring reflector ports cannot be added to an aggregation group.  

z 

Ports configured with blackhole MAC addresses, static MAC addresses or the static ARP protocol 

cannot be added to the aggregation group. 

z 

Ports where the IP-MAC address binding is configured cannot be added to an aggregation group.  

z 

Port-security-enabled ports cannot be added to an aggregation group.  

z 

The port with Voice VLAN enabled cannot be added to an aggregation group. 

z 

Do not add ports with IP filtering enabled to an aggregation group. 

z 

Do not add ports with ARP intrusion detection enabled to an aggregation group. 

z 

Do not add ports with source IP addresses/source MAC addresses statically bound to them to an 

aggregation group. 

z 

A port belonging to a port group cannot be added to an aggregation group. Conversely, a port 

belonging to an aggregation group cannot be added to a port group. 

 

You can create a manual aggregation group, or remove an existing manual aggregation group (after 

that, all the member ports in the group are removed from the ports). 

For a manual aggregation group, a port can only be manually added/removed to/from the manual 

aggregation group. 

Follow these steps to configure a manual aggregation group: 

Enter system view 

— 

Create a manual aggregation 
group 

link-aggregation group agg-id 
mode manual 

Required