3com WX3000 Manuel D’Utilisation

 

1-29 

Enter system view 

— 

Enable MSTP 

Required 
MSTP is disabled by default. 

Enter Ethernet port view 

 interface-type 

interface-number 

— 

Disable MSTP on the 
port 

Optional 
By default, MSTP is enabled on all ports after 
you enable MSTP in system view. 
To enable a device to operate more flexibly, 
you can disable MSTP on specific ports. As 
MSTP-disabled ports do not participate in 
spanning tree calculation, this operation saves 
CPU resources of the device. 

 

You are not recommended to enable MSTP on GigabitEthernet 1/0/29 on the switching engine of the 
WX3024, GigabitEthernet 1/0/11 on the switching engine of the WX3010 or GigabitEthernet 1/0/9 on 
the switching engine of the WX3008. 

 

Other MSTP-related settings can take effect only after MSTP is enabled on the device. 

# Enable MSTP on the device and disable MSTP on GigabitEthernet 1/0/1. 

1)  Perform this configuration in system view 

<device> system-view 

[device] stp enable 

[device] stp interface GigabitEthernet1/0/1 disable 

2)  Perform this configuration in Ethernet port view 

<device> system-view 

[device] stp enable 

[device] interface GigabitEthernet1/0/1 

[device-GigabitEthernet1/0/1] stp disable 

Complete the following tasks to configure a leaf node: 

Required 
To prevent network topology jitter caused by other 
related configurations, you are recommended to 
enable MSTP after performing other configurations. 

Required