3com WX3000 Manuel D’Utilisation

 

1-7 

Optional 

 

Synchronous information output refers to the feature that if the system information such as log, trap, or 

debugging information is output when the user is inputting commands, the command line prompt (in 

command editing mode a prompt, or a [Y/N] string in interaction mode) and the input information are 

echoed after the output. 

This feature is used in the case that your input is interrupted by a large amount of system output. With 

this feature enabled, the system echoes your previous input and you can continue your operations from 

where you were stopped. 

Follow these steps to configure synchronous information output: 

Enter system view 

— 

Enable synchronous 
information output 

info-center synchronous 

Required 

Disabled by default 

 

z 

If the system information is output before you input any information following the current command 

line prompt, the system does not echo any command line prompt after the system information 

output. 

z 

In the interaction mode, you are prompted for some information input. If the input is interrupted by 

system output, no system prompt (except the Y/N string) will be echoed after the output, but your 

input will be displayed in a new line. 

 

To add UTC time zone to the time stamp in the information center output information, you must: 

z 

Set the local time zone 

z 

Set the time stamp format in the output direction of the information center to date 

z 

Configure to add the UTC time zone to the output information 

Follow these steps to configure to display time stamp with the UTC time zone: 

Set the time zone for the system 

clock timezone zone-name 
{ add | minus } time 

Required 

By default, UTC time zone is 
set for the system. 

Enter system view 

system-view 

—