3com WX3000 Manuel D’Utilisation

 

2-3 

You can use the following commands to enable the two settings. 

Follow these steps to enable debugging and terminal display for a specific module: 

Enable system debugging for 
specific module 

debugging module-name 
[ debugging-option ] 

Required 

Disabled for all modules by 
default. 

Enable terminal display for 
debugging 

terminal debugging 

Required 

Disabled by default. 

 

The output of debugging information affects the system operation. Disable all debugging after you finish 

the system debugging. 

 

Follow these steps to display the current debugging status in the system: 

Display all enabled debugging 
on the current device 

display debugging [ unit 
unit-id ] [ interface 
interface-type 
interface-number ] 
[ module-name ] 

You can execute the display 
command in any view. 

 

When the device is in trouble, you may need to view a lot of operating information to locate the problem. 

Each functional module has its corresponding operating information display command(s). You can use 

the command here to display the current operating information about the modules in the system for 

troubleshooting your system. 

Follow these steps to display the current operation information about the modules in the system: 

Display the current operation 
information about the modules 
in the system. 

You can use this command in 
any view. 

You should execute this 
command twice to find the 
difference between the two 
executing results, thus helping 
locate the problem.