3com WX3000 Manuel D’Utilisation
1-18
# Display test results.
[device-hwping-administrator-icmp] display hwping results administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 3/6/3
Square-Sum of Round Trip Time: 145
Last succeeded test time: 2000-4-2 20:55:12.3
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[device-hwping-administrator-icmp] display hwping history administrator icmp
HWPing entry(admin administrator, tag icmp) history record:
Index Response Status LastRC Time
1 3 1 0 2000-04-02 20:55:12.3
2 4 1 0 2000-04-02 20:55:12.3
3 4 1 0 2000-04-02 20:55:12.2
4 3 1 0 2000-04-02 20:55:12.2
5 3 1 0 2000-04-02 20:55:12.2
For detailed output description, see the corresponding command manual.
DHCP Test
Network requirements
As shown in
, Switch A serves as a HWPing client and the DHCP server (Switch B) is an H3C
S5600 series Ethernet switch. Perform a HWPing DHCP test between the two devices to test the time
required for the HWPing client to obtain an IP address from the DHCP server.
Figure 1-3 Network diagram for the DHCP test
Switch A
Switch B
HWPing Client
IP network
10.2.2.2/8
DHCP Server
Vlan-int 1
Configuration procedure
z
Configure DHCP Server(Switch B):
Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to the DHCP
module.
z
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<device> system-view
[device] hwping-agent enable