3com WX3000 Manuel D’Utilisation
1-26
Network diagram
Figure 1-7 Network diagram for the SNMP test
Switch A
Switch B
HWPing Client
IP n etwork
10.1.1.1/8
10.2.2.2/8
SNMP Agent
Configuration procedure
z
Configure SNMP Agent (Switch B):
# Start SNMP agent and set SNMP version to V2C, read-only community name to "public", and
read-write community name to "private".
<Sysname> system-view
[Sysname] snmp-agent
[Sysname] snmp-agent sys-info version v2c
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
z
The SNMP network management function must be enabled on SNMP agent before it can receive
response packets.
z
The SNMPv2c version is used as reference in this example. This configuration may differ if the
system uses any other version of SNMP. For details, see SNMP – RMON Operation Manual.
z
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<device> system-view
[device] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "snmp".
[device] Hwping administrator snmp
# Configure the test type as snmp.
[device-hwping-administrator-snmp] test-type snmpquery
# Configure the destination IP address as 10.2.2.2.
[device-hwping-administrator-snmp] destination-ip 10.2.2.2
# Configure to make 10 probes per test.
[device-hwping-administrator-snmp] count 10
# Set the probe timeout time to 30 seconds.
[device-hwping-administrator-snmp] timeout 30
# Start the test.