3com WX3000 Manuel D’Utilisation

 

1-24 

Figure 1-6 Network diagram for the Jitter test 

Switch  A

Switch  B

HWPing Client

IP network

10.1.1.1/8

10.2.2.2/8

HWPing Server

 

 

z 

Configure HWPing Server (Switch B): 

# Enable the HWPing server and configure the IP address and port to listen on.  

<device> system-view 

[device] hwping-server enable 

[device] hwping-server udpecho 10.2.2.2 9000 

z 

Configure HWPing Client (Switch A): 

# Enable the HWPing client. 

<device> system-view 

[device] hwping-agent enable 

# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "Jitter". 

[device] hwping administrator Jitter 

# Configure the test type as jitter  

[device-hwping-administrator-Jitter] test-type Jitter 

# Configure the IP address of the HWPing server as 10.2.2.2.  

[device-hwping-administrator-Jitter] destination-ip 10.2.2.2 

# Configure the destination port on the HWPing server.  

[device-hwping-administrator-Jitter] destination-port 9000 

# Configure to make 10 probes per test.  

[device-hwping-administrator-http] count 10 

# Set the probe timeout time to 30 seconds. 

[device-hwping-administrator-Jitter] timeout 30 

# Start the test.  

[device-hwping-administrator-Jitter] test-enable 

# Display test results 

[device-hwping-administrator-Jitter] display hwping results administrator Jitter 

HWPing entry(admin administrator, tag Jitter) test result: 

      Destination ip address:10.2.2.2 

      Send operation times: 100             Receive response times: 100 

      Min/Max/Average Round Trip Time: 9/21/13 

      Square-Sum of Round Trip Time: 18623 

      Last complete test time: 2000-4-2 8:14:58.2 

  Extend result: 

      SD Maximal delay: 10                  DS Maximal delay: 10