Avaya C460 Manuel D’Utilisation

Chapter 2        Avaya C460 CLI Commands

96

Avaya C460 Reference Guide

Example:

L The entered value is the aging-time lower bound. The actual aging-time might 

be up to three minutes longer. 

User level: read-write, admin.
Use the set outband duplex command to configure the duplex type of the 
Ethernet Console port.
You can configure the Ethernet Console interface to either full duplex or half 
duplex. 
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation and an error message is generated if you attempt to set the transmission 
type of auto-negotiation Fast Ethernet ports to half- or full-duplex mode.

The syntax for this command is:

 {full | half}

Example:

User level: read-write, admin.
Use the set outbound negotiation command to enable or disable the link 
negotiation protocol on the Ethernet console port.
This command applies to the specific supervisor module where you execute it.
•

When negotiation is enabled, the speed and duplex of the outband Ethernet 
port is determined by auto-negotiation.

•

If negotiation is disabled, you can set the speed and duplex of the outband 
Ethernet port.

C460-1# set mac-aging-time 5

mac aging time is set to 5 minutes.

Full

Sets full-duplex transmission.

Half

Sets half-duplex transmission

C460-1# set outband duplex full

Ethernet Console interface set to full-duplex.