Avaya C460 Manuel D’Utilisation
Chapter 2 Avaya C460 CLI Commands
116
Avaya C460 Reference Guide
The syntax for this command is:
set port redundancy-intervals
<min-time-between-switchovers>
<switchback-interval> | none
Example:
set port spantree
User level: read-write, admin.
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
The syntax for this command is:
set port spantree
{enable|disable} [module/port]
Example:
min-time-between-switchovers
The minimum time between redundancy
switchovers for each pair (in milliseconds).
switchovers for each pair (in milliseconds).
switchback-interval
The period the primary port link has to be
“up” before the system switches back (in
milliseconds).
• If switchback interval is zero, the system
“up” before the system switches back (in
milliseconds).
• If switchback interval is zero, the system
never switches back
• If it is one, switchback occurs immediately
after the primary port link returns
none
The system switches bank only if the
secondary link fails.
secondary link fails.
C460-1# set port redundancy-intervals 100 20
Done!
enable|disable
Enables or disables the spanning tree mode for the
specified ports.
specified ports.
Module
Module number
Port
Port number
C460-1# set port spantree enable 3/1
port 3/1 was enabled on spantree