Avaya C460 Manuel D’Utilisation
Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide
187
show port
User level: read-only, read-write, admin.
Use the show port command to display port status on I/O modules.
Use the show port command to display port status on I/O modules.
The syntax for this command is:
show port
[<module>[/port]]
Example to display the status for port 4 on switch 3:
Show Port Output Fields
module
(Optional)
(Optional)
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
the ports on all the modules are shown.
port
(Optional)
(Optional)
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
C460-1> show port 3/4
Port Name Status Vlan Level Neg Dup. Spd. Type
------ --------------- --------- ---- ------ ------- ---- ---- -----------------
3/4 NO NAME no link 1 0 enable half 10M 10/100BaseTx Port
Field
Description
Port
Switch and port number
Name
Name of port
Status
Status of the port (connected, faulty, disabled)
Vlan
VLAN ID of the port
Level
Priority level of the port (0-7)
Neg
The autonegotiation status of the port (enabled, disabled)
Dup
Duplex setting for the port (full, half)
Speed
Speed setting for the port (10, 100, 1000)
Type
Port type, for example:
10/100BASE-TX, GBIC_SX, GBIC_LX, GBIC_not present,
GBIC_unknown
10/100BASE-TX, GBIC_SX, GBIC_LX, GBIC_not present,
GBIC_unknown