Avaya C460 Manuel D’Utilisation

Chapter 2        Avaya C460 CLI Commands

188

Avaya C460 Reference Guide

User level: read-write, admin.
Use the show port auto-negotiation-flowcontrol-advertisement 
command to display the flowcontrol advertisement for a Gigabit port used to 
perform auto-negotiation. 

The syntax for this command is:

[module/port] 

[mode] 

Example:

User level: read-only, read-write, admin.
Use the show port channel command to display Link Aggregation Group 
(LAG) information for a specific switch or port.

The syntax for this command is:

[<module>[/<port>]] [info] 

module
(Optional)

Number of the module (3-6). If you do not specify a number, 
the ports on all the modules are shown.

port
(Optional)

Number of the port on the module. If you do not specify a 
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for 
example, 4/5-13 for ports 5 to 13 on module 4.

mode

no-flowcontrol, asym-tx-only, sym-only or sym-and-asym-rx

C460-1> show port auto-negotiation-flowcontrol-

Port 4/49 pause capabilities was set

module
(Optional)

Number of the module (3-6). If you do not specify a number, 
the modules on all the switch are shown.

port
(Optional)

Number of the port on the module. If you do not specify a 
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for 
example, 4/5-13 for ports 5 to 13 on module 4.