Avaya P330-ML-ML Manuel D’Utilisation
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide
237
Example:
ip route
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
L If you are at the ”privileged” level, you can only access this command in
Configure mode. Type configure at the command prompt to enter configure
mode.
mode.
Use the ip route command to establish a static route.
Use the no ip route command to remove a static route.
You can edit (add or remove), individually, each one of the 3 possible next-hop
addresses for a static route.
Use the no ip route command to remove a static route.
You can edit (add or remove), individually, each one of the 3 possible next-hop
addresses for a static route.
The syntax for this command is:
[no] ip route <ip-address> <mask> <next-hop> [<next-hop>]
[<next-hop>] [<cost>] [<preference>]
Example:
To define the router 192.168.33.38 as the next hop for the network 192.168.33.0 with
mask 255.255.255.0:
To define the router 192.168.33.38 as the next hop for the network 192.168.33.0 with
mask 255.255.255.0:
ip routing
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Type configure at the command prompt to enter configure mode.
Router-N(configure router:ospf)# ip ospf router-id
192.168.49.1
ip-address
The IP address of the network
mask
Mask of the static route
next-hop
The next hop address in the network
cost
The path cost. The default is 1
preference
Preference, either High or Low. Default is Low.
Router-N(configure)# ip route 192.168.33.0 255.255.255.0
10.10.10.10