WatchGuard Technologies 700 Manuel D’Utilisation
Firebox System Area
Hardware Guide
23
Note that this procedure is possible only when a backup image is on the
backup area of the Firebox’s flash disk. There is no backup image on the
Firebox until you copy one there.
backup area of the Firebox’s flash disk. There is no backup image on the
Firebox until you copy one there.
1
Click the Control Center Main Menu button (shown at
right), which is located on the upper-left corner of
Control Center.
right), which is located on the upper-left corner of
Control Center.
2
Select Tools => Advanced => Flash Disk Management.
3
Select Restore Backup Image. Click Continue.
A verification prompt appears. Verify that the Management Station connects to
the Firebox Trusted interface either over the network (TCP/IP) or via a modem
using out-of-band management.
4
Click Yes.
The Connect To Firebox dialog box appears.
5
Use the Firebox drop list to select a Firebox or type the IP address
used by the Management Station to communicate with the Firebox.
Enter the configuration (read/write) passphrase. Click OK.
used by the Management Station to communicate with the Firebox.
Enter the configuration (read/write) passphrase. Click OK.
The Firebox copies the backup image from the backup area to the primary area of
its flash disk and reboots from the backup file.